Microsoft Computer Hardware Mainboard Manuel d'utilisateur télécharger pdf (Page 36)

Change Password

If you highlight this item and press Enter, a dialog box appears which lets you

enter a Supervisor password. You can enter no more than six letters or num-

bers. Press Enter after you have typed in the password. A second dialog box

asks you to retype the password for confirmation. Press Enter after you have

retyped it correctly. The password is then required to access the Setup Utility

or for that and at start-up, depending on the setting of the Password Check

item in Advanced Setup.

Change or Remove the Password

Highlight this item, press Enter and type in the current password. At the next

dialog box, type in the new password, or just press Enter to disable password

protection.

Exit

Highlight this item and press Enter to save the changes that you have made

in the Setup Utility configuration and exit the program. When the Save and

Exit dialog box appears, press Y to save and exit, or press N to exit without

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Microsoft Computer Hardware Mainboard Manuel d'utilisateur Page 36