Microsoft LPF-00004 Manuel de l'opérateur télécharger pdf (Page 89)

CMD300 CONTROL SOFTWARE Page 71

YBER

380, COPYRIGHT MARCH 2002, AXON INSTRUMENTS, INC.

UPLING + <coupling>

UPLING - <coupling>

UPLING + <coupling> - <coupling>

This command sets the positive and/or negative input coupling for the selected channels. The

allowed values for <coupling> are:

ND,

C, 0.1, 1, 10, 30, 100 and 300.

DEVICE <device number>

DEVICE OFF

This command specifies Axon expandable RS232 bus device numbers. By default, the

program does not use device numbers and hence assumes that the CyberAmp is the only

device on the RS232 bus on that COM port. If there are multiple units on the RS232 bus,

then each unit will need to be explicitly addressed by its unique device number. Once a

device number is used, it is remembered by the CMD300 program until device numbers are

disabled (DEVICE OFF) or until another device number is specified.

The <device number> may be in the range 0-9. The current device number may be reviewed

with the STATUS DEFAULTS command.

FILTER <filter value>

ILTER

This command sets the low-pass filter for the selected channels. To bypass the low-pass filter

use the command FILTER OFF. The permissible values for <filter value> are as follows:

4 40 400 4000

6 60 600 6000

8 80 800 8000

10 100 1000 10000

12 120 1200 12000

14 140 1400 14000

16 160 1600 16000

18 180 1800 18000

20 200 2000 20000

22 220 2200 22000

24 240 2400 24000

26 260 2600 26000

28 280 2800 28000

30 300 3000 30000

The letter "k" is a permissible shorthand for the whole multiples of 1000. (e.g., 10k is

equivalent to 10000).

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 156 157

Pas de commentaire

Microsoft LPF-00004 Manuel de l'opérateur Page 89