Microsoft LPF-00004 Manuel de l'opérateur télécharger pdf (Page 93)

CMD300 CONTROL SOFTWARE Page 75

YBER

380, COPYRIGHT MARCH 2002, AXON INSTRUMENTS, INC.

Command Details of Advanced Commands

The following advanced commands and modifiers are support by the CMD300 program. The

minimum abbreviation of the commands and modifiers is indicated by the large capitalized text

portion of each token.

21)

BEEP

This command causes the computer to briefly beep. It is useful in the command-file mode to

signal the user.

22)

CONT

INUOUS

This command sets the program into continuous command-file mode. If the program is

currently in command-file mode, then the current command file will be processed

continuously.

23)

DELAY <seconds delay>

This command delays the processing of subsequent commands by the number of seconds

specified. When used with the REPEAT command, it enables a command sequence to be

repeated at regular intervals. The following command displays the status of the CyberAmp

every 2.5 seconds.

CMD300 REPEAT STATUS DELAY 2.5

24)

ECHO ON

ECHO OFF

This command determines whether non-executable lines in a command file are echoed to the

output screen. The default setting is ON.

25)

FILE or @

This command specifies the name of a command file that is to be loaded in command-file

mode. The command file is loaded and is processed line by line until the end of the file, or

until a STEP command is processed, or until the user interrupts processing with the <Esc>

key. Only the filename itself is allowed to follow the FILE token.

26)

INTERACTIVE

This command places the program into interactive command mode. This command is only

allowed on the DOS command line.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 156 157

Pas de commentaire

Microsoft LPF-00004 Manuel de l'opérateur Page 93